They need to be placed on the "back side" of the PCB, facing the encoding wheel. It was an important consideration to me that the Venus 2000 would continue to be able to be used as it was originally intended, IE with the original remote control. Here are the files you need to produce your own PC boards. The Venus 2000 maker does not offer a receiver guide, but for hands free operation the Venus 2000 needs some sort of guide to hold the receiver is proper alignment. The first part is shown in the images below: In these images you can see that I have designed and mounted a new PC board inside the Venus 2000 motor housing. Place the liner over the end of the receiver, then slide the fleshlight into the liner so that the liner covers the ends of the receiver and the fleshlight case. By timing between rising edges only, that error is eliminated. July 23, 2015 at 1:44 am #4916 your making it too complicated. This PC board incorporates the simulated variable resistor, a relay for turning motor power on/off, and two photo reflectors for very precise sensing of the fly wheel's rotational position. The metal stand shown here has been further modified to interface with the CS-2000). This pressure/vacuum information can be used by a computer for additional analysis. IE the first cycle delivers a single stroke, and second cycle delivers two strokes, etc. I wanted the direct contact with the sleeve and it is Wow Wow Wow. The CS-2000 has a number of built in programming sequences that can be selected from the front panel, these are: Insert: - slowly stroke while removing air, to facilitate inserting the penis into the receiver. When shipped from the manufacturer, the device is controlled by a small hand held box which contains an on/off switch, a power indicator, and a variable resistor. MG Billing Limited, 195-197 Old Nicosia-Limassol Road, Dali Industrial Zone 2540, Block 1, Cyprus. Video Removed Undo, video Removed Undo, prostate Milking Cum Draining. Additional features include the ability to add or remove air under front panel control; to display the minimum and maximum positions of the receiver; and to automatically remove air periodically.